WHAT I DID: I deleted the CD copied version of uLE 3.41u (installed via CD in hdd0:/_boot/boot.elf), then copied uLE 4.04 (uncompressed) from mass:/boot.elf to hdd0:/_boot/boot.elf. Now coping boot.elf to hdd0:/_boot/boot.elf will allow me to boot from DEV2. I am running uLE v4.04 off mc0: when coping this file. Code: BOOT2 = cdrom0: DEV2I.ELF 1 VER = 1.10 VMODE = NTSC NOTE: 'VMODE' should be set to PAL (VMODE = PAL) if using a PAL PS2 of course. Here is what I have on my CD: - BOOT.ELF (uLE 3.41u - uncompressed) NOTE: This file will be converted to lowercase boot.elf in hdd0:/_boot/boot.elf during the install - DEV2I.ELF - DUMMY.BIN - DUMMY2.BIN - SYSTEM.CNF Contents of SYSTEM.CNF. Reason why I used this one is because I already had it burned on a cd. The BOOT.ELF file I used was uLaunchELF v3.41u (uncompressed version). I should of paid closer attention to huivzhopu's post #3 (glanced over it too quickly).
I had to use, after this it will work using uLaunchELF. I don't get it Last edited by ps2dragon at 06:32 PM.
EDIT: I tried again, this time using: - Matrix Infinity's firmware v1.54 (downgraded from v1.88 because I know v1.54 used to work) - 20GB Maxtor HDD (which used to work booting from HDD) - uLE v3.41u (uncompressed version with IOP Reset turned off using default CNF) in hdd0:/_boot/boot.elf (lowercase) - Set Matrix BOOT MODE to DEV2, and also tried holding L1 while set to DEV1 Still not working. It used to work fine before, I don't understand why it no longer works? I normally just boot from DEV1 anyway, but I just don't know why it's not working, where it used to work fine booting from my 20GB back when I was using v3.51. I tried booting to DEV2 using L1 and by changing the BOOT MODE to DEV2. I also went back to v3.51 (uncompressed and compressed), tried using the old default LAUNCHELF.CNF for v3.51 (uncompressed and compressed) and still it will not load. This is really strange, I'm still unable to boot uLE from a HDD. I'll post an update when I get WinHIIP running again, if I ever get my PC working. I thought it might have something to do with a change in the newer versions, but even v3.51 (which used to boot from HDD) isn't booting either (uncompressed and compressed versions). ULE works fine from the MC, just gets a black screen when booting from hdd0:/_boot/boot.elf.
I was going to try reformatting my HDD with WinHIIP and see if a newly formatted HDD would work. Unfortuntely, I can't do much right now as my PC died on me. Have you guys tried both compressed and non-compressed versions of ulaunchelf? Yes, that's not the issue. Virtual Memory Card Tutorial (Open PS2 Loader 0.8/Free McBoot) - Duration: 13:07.
0 kommentar(er)
